This little Toyota Hilux barely makes any power, and yet it can still climb a steep obstacle on the Rubicon Trail with ease. That’s because the ultimate solution for a lack of grunt is gearing. Let’s go over how it all works.

This 1981 Toyota Hilux doesn’t look like much to most people. And indeed, if you looked under the hood, you probably wouldn’t be particularly impressed. Yes, the original 100-ish horsepower 22R four-banger is gone, but the isn’t going to light up the tires either with its 150 ponies and 177 lb-ft.

But that’s okay, because off-roaders don’t need a lot of motor when they’ve got an insane Marlin Crawler Ultimate transfer case:

A reader named Paulo sent us this video in tips after this clip went up on Facebook showing the truck doing the slowest burnout in history:

We’ve explained the concept of before, but here’s a refresher. By sending an engine’s power through short gearing in a transmission, transfer case and differential, you can essentially trade RPM (which corresponds to vehicle speed) for torque, which is what is needed at the wheels to accelerate a vehicle over any obstacle.

Put more simply, if you take this Hilux’s 150 horsepower at 4,800 RPM, and send it through a bunch of gearing like “BigMike” did in this Hilux, you can get an absurd amount of thrust at the wheels. In this case, based on Marlin Crawler’s on Facebook, the gears in question are three transfer cases with gear ratios of 4.7, 2.28 and 2.28, a 5.29 rear differential ratio and a 3.95 first gear ratio. Multiply these ratios together, and you get the “crawl ratio,” which is the ratio of torque at the wheels to torque at your engine’s flywheel: 511.

So imagine this truck is turning at 4,800 RPM, where it makes a maximum of 164 lb-ft of torque (this corresponds to a max output of 150 horsepower). Send that torque through the 3.95 first gear, then through the three transfer cases, and through the rear diff, and you wind up with 164*511 = nearly 84,000 lb-ft of torque. Divide that by the tire’s radius to get the forward thrust (because force is a torque divided by a moment arm), and you get about 57,000 pounds. That’s almost literally unstoppable.

Granted, because power—which is proportional to RPM * torque— is conserved through the gearboxes, that increase in output torque is accompanied by a corresponding decrease in angular velocity. So the engine might be turning at 4,800 RPM, but the rear wheel is turning at 4,800/511 = 9.4 RPM. And considering 35-inch tires make , this means the vehicle will travel 0.95 mph at 4,600 rpm.

God that’s slow. But steady, at least.